Underfloor Heating Systems
Wet underfloor heating systems designed for use in screed, floating & suspended floor constructions
Thermal Mass -The Floor is the Heater
Warm water is circulated through pipe loops laid under the floor, effectively making the floor one large radiator, but at a much lower surface temperature than a normal radiator.
All types of floor and floor coverings are suitable, and the system can be run of any type of heat source; oil, gas, electric or solid fuel boiler and it works particularly well with Air source heat pumps (ASHP) and Ground source heat pumps (GSHP). The pipe loops are continuous so there is no risk of leak and the whole system is virtually maintenance-free.
Underfloor heating emits a higher proportion of its heat as radiant heat in the lower, occupied part of the room, not up at the ceiling. This is more comfortable to the body, and therefore the heat is concentrated where it is required.
The humidity is higher, so the room will not become stuffy, and as the heat is even over the whole area of the floor, there are no cold draughts, therefore you have warm feet and a cool head.
No Need for High Temperatures
Due to the radiant effect concentrating the heat in the lower part of the room and even distribution of the heat across the room, the room temperature can be maintained at a lower temperature then with a conventional radiator system.
This translates into an energy saving of between 15% to 40%. Also, the water temperature in the system is lower so the boiler efficiency will be enhanced too, particularly if a condensing boiler is used. Underfloor heating will also enhance the efficiency of a heat pump.
Dirt & Dust Free
As the underfloor heating system is built into the floor there are no crevices to encourage the build of dust and dirt, and as there is no hot air convection there is no dust movement and unsightly black marks above radiators.
Underfloor heating makes wood and tiled floor (which are easier to keep clean, and do not harbour dust mites) more comfortable and acceptable.
Design Friendly
One of the main problems with radiators is that they are always in the wrong place. People prefer to arrange their furniture to suit their own preference, not their heating engineer.
Underfloor heating gives total freedom always and does not use up wall space. Decorating is simpler – there are no radiators to paint, and wallpapering is easier. It can be brought into use earlier in a project to aid
drying out.
Bespoke Design
Underfloor heating systems are individually specified to suit customer requirements. All systems feature individual zones with temperature control, continuous joint-free pipe circuit, and pipe spacing to suit individual parameters.
We have many installation techniques for both concrete & timber floors (despite popular myth, underfloor heating is suitable for timber floors). Underfloor heating is suitable for all buildings, new & old, industrial, commercial and domestic. We have a solution for every requirement.
High Quality
Made from Dowlex 2344 multilayer construction with a central oxygen layer, the PE-RT 5-layer pipe is produced to very strict quality control standards and each coil is individually tested.
Suitable for continuous operation at 10 bar and 85-degree C, which far exceeds the characteristics of a pure plastic pipe, thus ensuring an exceptional margin of safety and unlimited life expectancy. The multilayer pipe is guaranteed to be permanently 100 % oxygen impermeable. Easily bent with minimal spring back ensures ease of installation